Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.5 RMON
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
935
The parameters have the following meaning:
Parameter
Description
Range of values / note
statistics
Shows counts for various packet char-
acteristics and sizes.
-
stats-index
Index number for the statistical values
1 ... 65535
alarms
Shows the threshold values and event
assignments for alarms.
-
events
Shows the status and the actions that
are triggered.
-
history
Shows the stored statistical values for
earlier transmission periods.
-
history-index
Index number for the previous statisti-
cal values
1 ... 65535
overview
Displays an overview.
-
With this command, you can display several parameters with one call.
If you do not select any parameters from the parameter list, only the
enabled or disabled
status is shown.
Result
The settings of the remote monitoring function are displayed.
12.5.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
12.5.2.1
rmon
Description
With this command, you enable the Remote Monitoring function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English