Siemens SCALANCE XM-400 - Snmp; The Show Commands; Show Snmp; Show Snmp Community

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
385
7.8
SNMP
This section describes commands of the Simple Network Management Protocol (SNMP).
7.8.1
The "show" commands
This section describes commands with which you display various settings.
7.8.1.1
show snmp
Description
This command shows the status information of SNMP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp
Result
The status information is displayed.
7.8.1.2
show snmp community
Description
This command shows the details of the configured of SNMP communities.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#