Siemens SCALANCE XM-400 - No Ipv6 Router Rip; Commands in the Ripng Router Configuration Mode

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
696 Configuration Manual, 06/2016, C79000-G8976-C252-11
Further notes
You disable routing with RIPng with the no ipv6 router rip command.
You display the setting and other information with the
show ipv6 rip command.
9.7.2.2
no ipv6 router rip
Description
With this command, you enable RIPng routing on the device.
Note
This command is available only with layer 3 (IPv6).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ipv6 router rip
Result
Routing with RIPng is disabled.
Further notes
You enable routing with RIP with the ipv6 router rip command.
You display the setting and other information with the
show ipv6 rip command.
9.7.3
Commands in the RIPng Router configuration mode
This section describes commands that you can call up in the Router Configuration mode.
In the global configuration mode, enter the
ipv6 router rip command to change to this
mode.