Siemens SCALANCE XM-400 - Show Dcp Forwarding

Network protocols
7.1 IPv4 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
288 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call the command without parameters:
show dcp server
Result
The overview of the status of the DCP function and access rights is displayed.
7.1.1.6
show dcp forwarding
Description
This command shows an overview of the DCP forwarding behavior on one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show dcp forwarding [port<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
port
Keyword for a an interface description
-
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The overview of the DCP forwarding behavior is displayed.