Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
650 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
Routing with VRRP3 is enabled.
You are now in the VRRP3 Router configuration mode.
The command prompt is as follows:
cli (config-vrrp-v3)#
Further notes
You disable routing with VRRP with the no router vrrp3 command.
You enable IPv6 routing with the
ipv6 unicast-routing command.
You configure an IPv6 address for the interface with the
ipv6 address command.
9.5.3.2
no router vrrp3
Description
With this command, you disable routing with VRRPv3.
Note
This command is available only with layer 3.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no router vrrp3
Result
Routing with VRRPv3 is disabled.
Further notes
You enable routing with VRRPv3 with the router vrrp3 command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English