Siemens SCALANCE XM-400 - No Dot1 X Mac-Auth Vlan-Assign

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
877
Syntax
Call the command without parameters:
dot1x mac-auth vlan-assign
Result
The VLAN ID for a MAC address is assigned by the RADIUS server.
Further notes
You disable the assignment of the VLAN ID for a MAC address by the RADIUS server with
the
no dot1x mac-auth vlan-assign command.
You display this setting and other information with the show dot1x command.
11.7.3.11
no dot1x mac-auth vlan-assign
Description
With this command you disable the assignment of the VLAN ID for a MAC address by the
RADIUS server.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x mac-auth vlan-assign
Result
The VLAN ID for a MAC address is no longer assigned by the RADIUS server.
Further notes
You enable the assignment of the VLAN ID for a MAC address by the RADIUS server with
the
dot1x mac-auth vlan-assign command.
You display this setting and other information with the show dot1x command.