Siemens SCALANCE XM-400 - Media Type

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
98 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Parameter
Description
transmit
the sending of LLDP packets is disabled
receive
the receipt of LLDP packets is disabled
Note
Disabling both options
When you call this command, you can only select one option.
If you want to disable both options, call up the command again.
Result
Sending or receipt of LLDP packets is disabled.
Further notes
You enable the sending or receipt of LLDP packets with the lldp command.
3.1.13.9
media type
Description
With this command, you configure the mode of a combo port.
Note
This command only influences combo ports.
If you attempt to configure a different port with this command, an err
or message will be
displayed.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
media-type {auto|rj45|sfp}