Siemens SCALANCE XM-400 - Ipv6 Protocol; Clear Ipv6 Traffic; The Show Commands; Show Ipv6 Neighbors

Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
306 Configuration Manual, 06/2016, C79000-G8976-C252-11
7.2
IPv6 protocol
This section describes the commands relevant for working with IPv6.
7.2.1
clear ipv6 traffic
Description
With this command, you reset the statistics counters to zero.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
clear ipv6 traffic
Result
The statistics counters have been reset.
Further notes
You display the statistics with the show ipv6 traffic command.
7.2.2
The "show" commands
This section describes commands with which you display various settings.
7.2.2.1
show ipv6 neighbors
Description
This command shows IPv6 neighbors table.