Siemens SCALANCE XM-400 - Snmp Notify

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
401
Parameter
Description
Range of values / note
UserName
Name of the user
max. 32 characters
security-model
Specifies which security settings are
used for sending
•
v1
•
v2c
•
v3
Result
The details of the group are deleted.
Further notes
You change the details of an SNMP group with the snmp group command.
You display the created SNMP groups with the
show snmp group command.
You display the created SNMP user with the
show snmp user command.
7.8.2.12
snmp notify
Description
With this command, you configure the details of the SNMP notifications.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp notify <NotifyName> tag <TagName> type {Trap|Inform}
[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
NotifyName
Name of the SNMP notification
max. 32 characters
tag
Keyword for a target key
-
TagName
Name of the target key
max. 32 characters