Siemens SCALANCE XM-400 - Ipv6 Ospf Transmit-Delay

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
614 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The interval is reset.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You configure the interval with the
ipv6 ospf retransmit-interval command.
You display the configuration with the
show ipv6 ospf interface command.
9.3.4.15
ipv6 ospf transmit-delay
Description
With this command you specify the time that a link state update packet requires for
transmission.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Requirement
● Layer 3 interface
● The router ID is configured.