Siemens SCALANCE XM-400 - Commands in the Interface Configuration Mode; Dot1 X Guest-Vlan

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
870 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
MAC authentication is disabled for the device.
Further notes
You enable the function with the dot1x mac-auth command.
You display this setting and other information with the show dot1x command.
11.7.3
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
11.7.3.1
dot1x guest-vlan
Description
With this command, you enable the guest VLAN function for a port.
This function is also known as "Authentication failed VLAN".
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
dot1x guest-vlan
Result
The guest VLAN function is enabled for the device.