Siemens SCALANCE XM-400 - Commands in the Global Configuration Mode; Monitor

Diagnostics
12.4 Port Mirroring
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
924 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show monitor {session <session-id(1-7)>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
session
Keyword for a session whose settings
are displayed
-
session-id
Number of the session
1 ... 7
Result
The settings for mirroring ports are displayed.
12.4.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
12.4.2.1
monitor
Description
With this command, you enable the port mirroring function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#