Diagnostics
12.5 RMON
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
938 Configuration Manual, 06/2016, C79000-G8976-C252-11
If you do not select a parameter from the parameter list, the events for high and low
threshold values are assigned the lowest event number available in the event table.
Note
MIB variables that can be monitored
With the RMON function, only MIB
variables of the Ethernet interfaces can be monitored.
Note
Magnitude of the threshold values
The threshold value for falling or low variable values should be less than the threshold value
for rising or high variable values.
Note
Conditions for working with alarms
The events assigned to the alarms are configured.
The Remote monitoring function is started with the rmon
command.
The alarm for monitoring a MIB variable is configured.
You delete an alarm with the no rmon alarm command.
You display the list of configured RMON alarms with the
show rmon alarms command.
no rmon alarm
Description
With this command, you delete an alarm for monitoring a MIB variable.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters: