Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
653
The VRRP3 interface has been deleted.
You configure a VRRP3 interface with the interface command.
You display the status and the configuration of the VRRP3 interface with the
show vrrp3 or
show vrrp3 interface command.
track interface
Description
With this command, you configure the tracking of interfaces.
When the link of one or more tracked interfaces changes from "up" to "down", the priority of
the assigned VRRP interface is reduced. When the link of the interface changes back from
"down" to "up", the original priority of the VRRP interface is restored.
Note
This command is available only with layer 3.
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3)#
Call up the command with the following parameters:
track <group-index> interface { vlan <vlan-id (1-4094)> | <interface-type>
<interface-id> }
The parameters have the following meaning:
ID of the interface tracking
Keyword for a VLAN connection
Number of the addressed VLAN
Specify a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
To Next Page
Loading...
Need help?
General