Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
685
Result
The information forwarded by RIP has been specified.
9.6.3.10
no redistribute
Description
This command specifies which route information is not forwarded by RIP.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
no redistribute {all | default | connected | ospf | static} [route-map <name(20)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
all
The forwarding of route information is
disabled for all protocols.
-
default
Default routes are not forwarded. -
connected
Route information of local subnets is
not forwarded.
-
ospf
No routes learned by OSPF are dis-
tributed.
-
static
No static routes are forwarded.
-
route-map
Keyword for a route map.
-
name
Name of the route map.
Maximum of 20 characters
Result
In certain cases, forwarding of routing information is disabled.
9.6.3.11
version
Description
With this command, you specify which version the RIP protocol uses to send and receive
routing information.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English