To Next Page

To Previous Page

Network structures

6.1 VLAN

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

217

6.1.3.22

tia interface

Description

With this command, you enable or disable the property TIA interface. The interface can be

used for PROFINET.

Requirement

● The interface is enabled.

● You are in the Interface configuration mode of the VLAN interface.

The command prompt is:

cli (config-if-vlan-$$$) #

$$$ stands for the numbering of the interface.

Syntax

Call the command without parameters:

tia-interface

Result

The TIA interface property is enabled exclusively for the specified VLAN. The function was

disabled on the other interfaces.

Further notes

Note that only one VLAN interface can become the TIA interface.

6.1.4

Commands in the VLAN configuration mode

This section describes commands that you can call up in the VLAN Configuration mode.

In the Global Configuration mode, enter the

vlan $$$ command to change to this mode.

When doing this, you need to replace the

$$$ placeholders with the relevant VLAN ID.

Commands relating to other topics that can be called in the VLAN Configuration mode can

be found in the relevant sections.

● If you exit the VLAN Configuration mode with the

exit command, you return to the Global

Configuration mode.

● If you exit the VLAN Configuration mode with the

end command, you return to the

Privileged EXEC mode.

Siemens SCALANCE XM-400 Configuration Manual

Other manuals for Siemens SCALANCE XM-400