Siemens SCALANCE XM-400 - Router Pim; Ip Pim Static-Rp

Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
763
9.10.3.3
router pim
Description
With this command, you change to the PIM configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
router pim
Result
You are now in the PIM configuration mode.
The command prompt is as follows:
cli(router-pim)#
Further notes
You enable PIM globally on the device with the ip pim routing command.
9.10.3.4
ip pim static-rp
Description
With this command, you configure the device as a static rendezvous point.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip pim static-rp