Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
771
You define interface candidates for the bootstrap router with the ip pim bsr-candidate
command.
You can display information about the selected bootstrap router with the
show ip pim bsr
command.
With this command, you assign an interface to PIM.
● The interface is not a router port.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
ip pim
The interface is assigned to PIM.
You delete the assignment with the no ip pim command.
With this command, you delete the assignment of an interface to PIM.