Siemens SCALANCE XM-400 - No Redist-Config

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
543
Syntax
Call up the command with the following parameters:
redist-config <Network> <Mask>
[metric-value <metric (1 - 16777215)>]
[metrictype {
asExttype1 | asExttype2
}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
Network
Target address of the route.
enter the IPv4 address.
Mask
Subnet mask of this route specify the subnet mask.
metric-value
Keyword for the metric of the route
-
metric
Metric
1 - 16777215
metrictype
Keyword for the connection costs
•
asExttype1
External and internal costs
•
asExttype2
External costs
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The information for the route is specified.
Further notes
You remove the information with the no redist-config command.
You distribute the routes with the
restribute command.
9.2.3.20
no redist-config
Description
With this command, you delete the information for the new external routes.
Note
This command is available only with layer 3.