Siemens SCALANCE XM-400 - No ASBR Router

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
590 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The autonomous system boundary router is enabled.
Further notes
You disable the autonomous system boundary router with the no ASBR Router command.
You enable the distribution of the routes with the
redistribute command.
You create the information for the routes with the
redist-config command.
You can display the status of this function and other information with the
show ipv6 ospf
command.
9.3.3.9
no ASBR Router
Description
With this command, you disable the autonomous system boundary router.
Note
This command is available only with layer
3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call the command without parameters:
no ASBR Router
Result
The autonomous system boundary router is disabled.
Further notes
You enable the autonomous system boundary router with the ASBR Router command.
You can display the status of this function and other information with the
show ipv6 ospf
command.