Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
632 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The IPv4 addresses are specified.
Further notes
You can create a maximum of 52 virtual IP addresses.
You configure a VRRP interface with the
interface command.
You remove an IPv4 address with the
no vrrp associated-ip command.
You remove all IPv4 addresses with the
vrrp group shutdown command.
You display the IPv4 addresses with the
show vrrp interface - vrid command.
9.4.4.2
no vrrp associated-ip
Description
With this command, you remove an IPv4 address from the virtual router.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> associated-ip <ip_addr>
The parameters have the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
ip_addr
Value for an IPv4 address
Enter a valid IPv4 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IPv4 address is removed from the virtual router.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English