EasyManuals Logo

Siemens SCALANCE XM-400 Configuration Manual

Siemens SCALANCE XM-400
960 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #518 background imageLoading...
Page #518 background image
Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
518 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.2.1.8
show ip ospf request-list
Description
This command shows the request list. This request list contains the information required for
the LSAs.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip ospf request-list
[<neighbor-id>]
[{
vlan <vlan-id (1-4094)> |
<interface-type> <interface-id>
}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
neighbor-id
Router ID of the neighbor Enter the router ID. The router ID
consists of 4 numbers each be-
tween 0 and 255.
vlan
Keyword for a VLAN connection -
vlan-id
Number of the addressed VLAN
1 ... 4094
interface-type
Type of interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the request list is displayed for all
neighbors.
Result
The request list displayed.

Table of Contents

Other manuals for Siemens SCALANCE XM-400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XM-400 and is the answer not in the manual?

Siemens SCALANCE XM-400 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XM-400
CategorySwitch
LanguageEnglish

Related product manuals