Siemens SCALANCE XM-400 - Ipv6 Dhcp Relay Remote-ID Userdefined

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
384 Configuration Manual, 06/2016, C79000-G8976-C252-11
7.7.4.5
ipv6 dhcp relay remote-id userDefined
Description
With this command, you configure a designation for the remote ID.
Requirement
● The interface is an IPv6 interface.
● The DHCPv6 relay agent is enabled.
● In "
remote-id type", userDefined is set.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ipv6 dhcp relay remote-id userDefined <user-specific-ascii string(128)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
user-specific-
ascii
Designation of the remote ID. max. 128 characters
Result
The designation is specified.
Further notes
You enable the remote ID with the ipv6 dhcp relay remote-id. command.
You enable the DHCPv6 relay agent with the
ipv6 address dhcp relay command.
You configure the interface as a router port with the
no switchport command.
You configure the remote ID type with the
ipv6 dhcp relay remote-id type command.