Network protocols
7.5 DHCP server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
352 Configuration Manual, 06/2016, C79000-G8976-C252-11
no ip dhcp-server pool
Description
With this command, you delete the required IPv4 address band.
● The IPv4 address band is not enabled.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no ip dhcp
-server pool <pool
-id (1
-24)> The parameter has the following meaning:
ID of the addressed IPv4 address band
The required IPv4 address band is deleted.
You create an IPv4 address band with the ip dhcp-server poolcommand.
Commands in the DHCPPOOL configuration mode
This section describes commands that you can call up in the DHCPPOOL Configuration
mode.
In the Global Configuration mode, enter the
ip dhcp-server pool command to change to this
mode.
● If you exit the DHCPPOOL Configuration mode with the
exit command, you return to the
Global Configuration mode.
● If you exit the DHCPPOOL Configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General