Siemens SCALANCE XM-400 - Page 351

Network protocols
7.5 DHCP server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
351
specified interface assigned directly to it. This is followed by a change to the DHCPPOOL
configuration mode. You then configure the other settings in the DHCPPOOL
configuration mode.
3. If you call the
ip dhcp-server pool command without parameters, and IPv4 address band
with the next free pool ID is created and you change directly to the corresponding
DHCPPOOL configuration mode.
You then configure the interface and the other settings in the DHCPPOOL configuration
mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp-server pool [{ <pool-id (1-24)> | [{ vlan <vlan-id (1-4094)> | <interface-
type> <interface-id> }]}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
pool-id
ID of the addressed IPv4 address band
1 ... 24
vlan
Keyword for a VLAN connection -
vlan-id
Number of the addressed VLAN
1 ... 4094
interface-type
Type of interface
Specify a valid interface.
interface-id
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Auto-
Hotspot".
Result
The ID of the addressed IPv4 address band is configured.
You are now in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Further notes
You exit the DHCPPOOL configuration mode with the exit command.
You delete the entry with the
no ip dhcp-server pool command.