Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
192 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Number of the addressed VLAN
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you address several VLANs, you must insert a blank before and after the hyphen, for
example
no interface range vlan 5 - 10.
The VLANs have been removed from the specified interface area.
With the interface range command, you can put several interfaces or VLANs together to be
able to configure them together.
With this command, you assign a protocol to a protocol group.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
map protocol
{ip | novell | netbios | appletalk | other <aa:aa>}
enet-v2 protocols-group <Group id integer(1-100)>
The parameters have the following meaning:
Internet Protocol v4
To Next Page
Loading...
Need help?
General