Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
622 Configuration Manual, 06/2016, C79000-G8976-C252-11
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Call up the command with the following parameters:
interface vlan<vlan-id(1-4094)>
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 … 4094
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
You exit the VRRP Interface configuration mode with the end or exit command.
You delete a VRRP interface with the
no interface command.
You display the status and the configuration of the VRRP interfaces with the
show vrrp or
show vrrp interface command.
With this command, you delete a VRRP interface.
Note
This command is available only with layer 3.
To Next Page
Loading...
Need help?
General