Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.5 DHCP server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
346 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
● DHCPv6 Is activated.
● The DUID is of the type
llt or ll
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp client-id interface {<interface-type> <interface-id>}
The parameters have the following meaning:
Parameters
Description
Range of values / note
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Slot no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP interface is assigned.
Further notes
You enable the function DHCPv6 client with the ipv6 address dhcp command.
You configure the DUID with the
ipv6 dhcp client-id type command.
7.5
DHCP server
This section describes commands relevant for configuring the DHCP server.
Requirement
The connected devices are configured so that they obtain the IPv4 address from a DHCP
server.
7.5.1
The "show" commands
This section describes commands with which you display various settings.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English