Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
225
no private-vlan association
Description
With this command you delete the link between secondary PVLANs and a primary PVLAN.
● The interface is configured as a primary PVLAN.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call the command without parameter assignment:
no private-vlan association
The secondary PVLANs are not assigned to the primary PVLAN.
You assign secondary PVLANs to a primary PVLAN with the command private-vlan
association
.
You display this setting with the command.
You configure a an interface as a primary PVLAN with the
private-vlan command.
transparent-vlan
Description
With this command, you change a VLAN to the transparent mode.
Ports that were assigned to this VLAN as members or untagged members now become
transparent ports.
This means the following:
● The port VLAN ID of the transparent ports is set to the ID of this VLAN.
● Untagged frames that are received at these ports are forwarded to all other transparent
ports once again without tag as long as they are not forwarded to a standard VLAN by a
protocol or subnet rule.
● Frames tagged with VLAN ID "0" and that are received at these ports are forwarded to all
other transparent ports once again tagged with VLAN ID "0" as long as they are not
forwarded to a standard VLAN by a protocol or subnet rule.