Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.2 RADIUS client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
822 Configuration Manual, 06/2016, C79000-G8976-C252-11
Parameter
Description
Range of values / note
key
Keyword for the key for communication
between the authenticator and the
server
-
secret-key-string
Value for the key 127 characters
Default: "default"
primary
Identifies the RADIUS server as prima-
ry server
-
login
The server is used only for the login
authentication.
-
dot1x
The server is used only for the 802.1X
authentication.
-
login-dot1x
The server is used for both authentica-
tion procedures.
Default setting
test
Tests whether or not the specified
RADIUS server is available. At the
same time you can create a new
RADIUS server and run the test.
-
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 42)".
If optional parameters are not specified when configuring, the default values apply.
Note
Primary server
In a network, only one RADIUS server can be selected as the primary server.
If you select a RADIUS ser
ver as the primary server, this replaces the server that previously
had the role of primary server.
11.2.2.5
no radius-server
Description
With this command, you delete a RADIUS server entry on the RADIUS client.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English