Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
261
Syntax
Call up the command with the following parameters:
spanning-tree mst<instance-id(1-64)>
{cost(0-200000000)|port-priority (0-240)|disable}
The parameters have the following meaning:
Parameter
Description
Range of values / note
instance-id
Number of the addressed instance
1 ... 64
cost
Costs of the port for calculating the
lowest cost path.
0 ... 200000000
Default:
• 200000 for physical interfaces
• 199999 for port channels
port-priority
Priority of the interface 0 ... 240 in steps of 16
Default: 128
disable
disables the interface for multiple
spanning tree
-
Default:
The Multiple Spanning Tree func-
tion is enabled on the interface
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected property is configured.
Further notes
You can reset the setting to the default with the no spanning-tree mst (properties) command.
You display these settings and other information with the commands that start with
show
spanning tree ...
.
6.3.5.4
no spanning-tree mst
Description
With this command, you reset the various properties of the Multiple Spanning Tree function
to the default value.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English