Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
266 Configuration Manual, 06/2016, C79000-G8976-C252-11
Call up the command with the following parameters:
spanning-tree bpdufilter{disable|enable}
The parameters have the following meaning:
The transfer of BPDU packets is disa-
Default: disabled
The transfer of BPDU packets is ena-
bled for the port
-
The BPDU transmit status is configured.
spanning-tree layer2-gateway-port
Description
With this command, you configure a port as a layer 2 gateway port.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
spanning-tree layer2-gateway-port
The port is configured as a layer 2 gateway port.
You delete the configuration of a port as a layer 2 gateway port with the commandno
spanning-tree layer2-gateway-port
.
You can display other information with the
show spanning-tree interface command with the
detail option.
To Next Page
Loading...
Need help?
General