Siemens SCALANCE XM-400 - Track Links

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
626 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.4.3.5
track links
Description
With this command you define how many tracked interfaces need to change to the "down"
status, before the priority of the assigned VRRP interface is changed.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call up the command with the following parameters:
track <group-index> links <links-to-track(1-255)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
group-index
ID of the interface tracking
-
links-to-track
Number of interfaces
1 ... 255
Result
The number of tracked interfaces is defined.
Further notes
You delete the configuration with the no track links command.
You configure the tracking of interfaces with the
track interface command.
You display the configured number of tracked interfaces with the
show vrrp track command.