Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
451
Result
The interval is reset.
Further notes
You define the interval with the ip igmp query-interval command.
You display the setting and other information with the
show ip igmp global-config
command.
8.2.3.13
ip igmp query-max-response-time
Description
With this command you specify the period of time in an IGMP query that the client has to
respond to a query.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp query-max-response-time <value (1-255) tenths of seconds>
The parameters have the following meaning:
Parameter
Description
Range of values / note
value
Value for the time interval 1 ... 255
Default: 100
tenths of seconds
Specified in tenths of seconds -
Result
The period of time is specified.
Further notes
You can reset the time to the default with the no ip igmp query-max-response-time
command.
You display the setting and other information with the
show ip igmp global-config
command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English