Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
717
Syntax
Call up the command with the following parameters:
match interface {Vlan < vlan-id(1-4094)> | <interface-type> < interface-id> }
The parameters have the following meaning:
Parameter
Description
Range of values / note
Vlan
Keyword for a VLAN
-
vlan-id
Keyword for a VLAN connection 1 ... 4094
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the
interface
Result
The filter for the interface is created.
Further notes
You delete the filter for the interface with the no match interface command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
9.8.3.6
no match interface
Description
With this command, you delete the filter for the interface.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Syntax
Call up the command with the following parameters:
no match interface {Vlan < vlan-id(1-4094)> | <interface-type> < interface-id> }

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English