Network protocols
7.12 ARP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
425
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
arp <ip address> <hardware address> {Vlan <vlan-id(1-4094)> | <interface-type>
<interface-id> | Cpu0}
The parameters have the following meaning:
Value for the IP address to be linked to
a device (physical address)
IP address or IP alias
Physical address that will be linked
with the IP address
MAC address of the device
Keyword for a VLAN connection
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
The interface is configured as "Out-of-
band management interface"
-
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 44)".
The entry is generated in the ARP cache.
You delete a static entry from the ARP cache with the no arp command.
You can display the status of this function and other information with the
show ip arp
command.
You configure the router port with the
no switchport command.
With this command, you delete an entry from the ARP cache.
To Next Page
Loading...
Need help?
General