Siemens SCALANCE XM-400 - Radius-Server

Security and authentication
11.2 RADIUS client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
821
Further notes
You can display the status of this function and other information with the show device
information
command.
11.2.2.4
radius-server
Description
With this command, you configure a RADIUS server entry on the RADIUS client.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
radius-server { ipv4 <ipv4-address> | fqdn-name <FQDN> | ipv6 <ipv6-address> } [auth-
port <portno(1-65535)>] [retransmit <1-5>] [key <secret-key-string>] [primary]
[{login | dot1x | login-dot1x}] [test]
The parameters have the following meaning:
Parameter
Description
Range of values / note
ipv4
Keyword for an IPv4 address
-
ipv4-address
IPv4 address of the RADIUS server
Enter a valid IPv4 address.
fqdn-name
Keyword for a domain name
-
FQDN
Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
ipv6
Keyword for an IPv6 address
-
ipv6-address
IPv6 address of the RADIUS server
Enter a valid IPv6 address.
auth-port
Keyword for the UDP port number for
authentication
portno
Number of the port 1 … 65535
Default: 1812
retransmit
Keyword for the number of connection
retries
-
-
Enter the maximum number of retries
for an attempted query.
The initial connection attempt is re-
peated the number of times specified
here before another configured
RADIUS server is queried or the login
counts as having failed.
1 … 5
Default: 3 (retries, this means 4
connection attempts)