Security and authentication
11.2 RADIUS client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
818 Configuration Manual, 06/2016, C79000-G8976-C252-11
Call up the command with the following parameters:
show radius server [{<ucast_addr> | <ip6_addr>}]
The parameters have the following meaning:
Value for an IPv4 unicast address
Enter a valid unicast address.
Value for an IPv6 address Enter a valid IPv6 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, all configured RADIUS servers are displayed.
The RADIUS server configuration is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
login authentication
Description
With this command, you enable authentication via a RADIUS server.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
login authentication {radius | local-and-radius | radius-fallback-local}
To Next Page
Loading...
Need help?
General