Siemens SCALANCE XM-400 - No Ip Ospf Message-Digest-Key

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
560 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf message-digest-key <Key-ID (0-255)> md5 <md5-Key (16)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
Key-ID
ID of the password
0 ... 255
md5
Keyword for the password -
md5-Key
Password for authentication enter a password
Maximum length: 16 characters
Result
The password and the ID are specified.
Further notes
You delete the password with the no ip ospf message-digest-key command.
9.2.4.12
no ip ospf message-digest-key
Description
With this command, you delete the required password.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#