Siemens SCALANCE XM-400 - Show Ip Static Route; Show Ip Gateway

Network protocols
7.1 IPv4 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
286 Configuration Manual, 06/2016, C79000-G8976-C252-11
Parameter
Description
Range of values / note
rip
Shows the RIP entries in the routing
table.
static
Shows the static routes in the table. -
summary
Shows a summary.
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IPv4 routing table is displayed.
7.1.1.2
show ip static route
Description
This command shows the routes that were generated statically.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip static route
Result
The static routes are displayed.
7.1.1.3
show ip gateway
Description
This command shows the default gateway configured for the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#