Siemens SCALANCE XM-400 - Show Snmp Tcp; Show Snmp User

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
390 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call the command without parameters:
show snmp targetparam
Result
The configured SNMP target parameters are displayed.
7.8.1.11
show snmp tcp
Description
This command shows the configuration for SNMP via TCP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp tcp
Result
The configuration for SNMP via TCP is displayed.
7.8.1.12
show snmp user
Description
This command shows the settings for the SNMP user.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#