Siemens SCALANCE XM-400 - Ip Nat Napt; No Ip Nat Napt

Layer 3 functions
9.9 NAT (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
744 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.9.3.3
ip nat napt
Description
With this command, you enable NAPT for the selected IP interface.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ip nat napt
Result
NAPT is activated for the selected IP interface.
Further notes
You disable NAPT for the selected IP interface with the no ip nat napt command.
You display the current configuration with the
show ip nat summary command.
9.9.3.4
no ip nat napt
Description
With this command, you disable NAPT for the selected IP interface.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip nat napt