Layer 2 management protocols
8.3 IGMP snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
462 Configuration Manual, 06/2016, C79000-G8976-C252-11
ip igmp snooping version
Description
This command specifies which version of IGMP snooping the device will use. When shipped,
the device uses IGMPv3.
Note
There is no separate show command to display the version of IGMP used by the d
evice.
This information is shown when you enter the
show ip igmp snooping command in the User
EXEC mode or in the Privileged EXEC mode.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
ip igmp snooping version {v1 | v2 | v3}
The parameters have the following meaning:
The version of IGMP snooping used by the device is specified.
ip igmp vlan-snooping
Description
With this command, you enable IGMP snooping for all VLANs.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General