Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
79
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameters from the parameter list, the default values are used.
Result
The messages relating to the response of the called node are displayed.
3.1.10
ping ipv6
Description
With this command, you request a response from a device in the network. This allows you to
check whether or not another node is reachable.
Requirement
● IPv6 is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
ping ipv6 <prefix%interface>
[repeat <count>]
[size <value>]
[anycast]
[source {vlan <id> | <source_prefix>}]
[timeout <value (1-100)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
prefix
IPv6 address of the destination
Enter a valid IPv6 address.
%interface
optional parameter
Only necessary when the IPv6 ad-
dress of the destination is a link-local
address.
Specify the interface via which the
packet will be sent.
repeat
Keyword for the number of packets
to be requested
-
count
Number of packets 1 … 10
Default: 5

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English