Siemens SCALANCE XM-400 - Show Spanning-Tree Mst Interface

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
240 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show spanning-tree mst configuration
Result
The settings of an instance of the Multiple Spanning Tree protocol are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the show spanning-tree
command.
6.3.1.9
show spanning-tree mst interface
Description
This command shows port-specific settings of a Multiple Spanning Tree configuration.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with one of the following parameter assignments:
show spanning-tree mst
[<instance-id(1-64|4094)>] interface <interface-type><interface-id>
[{stats|hello-time|detail}]