Siemens SCALANCE XM-400 Configuration Manual

Load control
10.2 Static MAC filtering
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
787
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
switchport ingress-filter
Result
The ingress filter is activated.
Further notes
You disable the filter with the no switchport ingress-filter command.
You can display the status of the ingress filter and other settings with the
show vlan port
config
command.
10.2.2.2
no switchport ingress-filter
Description
With this command, you disable the ingress filter.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport ingress-filter
Result
The ingress filter is deactivated.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English