Siemens SCALANCE XM-400 - No Ip Dhcp Relay Remote-ID

Network protocols
7.6 DHCPv4 Relay Agent (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
375
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ip dhcp relay remote-id <remote-id name>
The parameter has the following meaning:
Parameter
Description
Range of values / note
remote-id name
Device ID max. 32 characters
Default: XYZ
Result
The device ID is specified.
Further notes
You remove the device ID with the no ip dhcp relay remote-id command.
You display the IP addresses with the
show dhcp server command.
You display the settings with the
show ip dhcp relay information command.
7.6.3.4
no ip dhcp relay remote-id
Description
With this command, you remove the device identifier.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay remote-id