Layer 2 management protocols
8.5 Ring redundancy and standby connection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
484 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
The ports for a standby connection are disabled.
You enable the setting with the standby port command.
You can display the status of this function and other information with the
show ring-
redundancy
command.
standby wait-for-partner
Description
With this command, you enable the "Wait for standby partner" function on the device. A
standby connection is enabled only after the standby master and the standby slave as well
as their standby partners have established a connection. This ensures that the redundant
connection is really available before communication via a standby connection is enabled. As
default, this function is enabled.
You are in the Redundancy configuration mode.
The command prompt is as follows:
cli(config-red)#
Call the command without parameters:
standby wait-for-partner
The "Wait for standby partner" function is enabled.
To Next Page
Loading...
