Network protocols
7.6 DHCPv4 Relay Agent (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
369
Call up the command with the following parameters:
no ip dhcp server <ip address>
The parameter has the following meaning:
IP address of the DHCP server Enter the IP address to be delet-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
The IP address is removed.
You enable the DHCP Relay Agent with the service dhcp-relay command.
You create the IP address with the
ip dhcp server command.
You display the IP addresses with the
show dhcp server command.
ip dhcp relay circuit-id option
Description
The Circuit ID is a sub option of the "DHCP Relay Information" option. The Circuit ID
contains information about the origin of the DHCP packet.
With this command, you specify the information contained in the Circuit ID.
The Circuit ID is encoded in the DHCP packet if the "DHCP relay information" option is
enabled.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
ip dhcp relay circuit-id option [router-index] [vlanid] [recv-port]
To Next Page
Loading...
Need help?
General