Siemens SCALANCE XM-400 - No Distance

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
698 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Parameter
Description
Range of values / note
dist
The value for the administrative dis-
tance.
1 ... 255
Default: 120
route-map
Keyword for a route map -
name
Name of the route map
Maximum of 20 characters.
Result
The value for the administrative distance is set.
Further notes
You reset the administrative distance to the default with the no distance command.
9.7.3.2
no distance
Description
With this command, you reset the administrative distance back to the default value.
Requirement
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Syntax
Call up the command with the following parameters:
no distance [route-map <name(20)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
route-map
Keyword for a route map
-
name
Name of the route map
Maximum of 20 characters.
Result
The value for the administrative distance is reset.